Check The Card Leds - Avaya IP Office Installation Manual

5.12 Check the Card LEDs

IP500 Analog Phone Base Card
Analog Extension Ports (1-8)
• LED1 only is used.
LED1 is used for card status:
• Red On - Error
• Red Flashing - Initializing.
• Red Flash every 5 seconds - Okay.
IP500 Digital Station Base Card
Digital Station Ports (1-8)
• Green On - Phone detected.
LED1 is used for card status:
• Red On - Error
• Red Flashing - Initializing.
• Red Flash every 5 seconds - Okay.
IP500 VCM Base Card
• LEDs 1 to 8 are unlabelled. They are used to indicate voice compression channel usage. Each LED lit represents
12.5% of the available voice compression channel capacity in use (total card capacity rather than licensed
capacity).
• LED1 is used for general card status. Flash every 5 seconds = Okay.
IP500 Trunk Daughter Cards
Daughter Card Ports (9-12)
The LED's for ports 9 and 10 are used as follows:
• Off: No trunk present/Analog - Idle.
• Green on: BRI/PRO trunk present.
• Green flashing: Trunk in use.
• Red/Green Fast Flash (port 9) or Green Fast Flash (port 10):
Alarm indication signal (AIS) from the PRI trunk remote end.
• Red with Green Blink (port 9) or Green Blink (port 1):
PRI Port in loopback mode (set through IP Office System Monitor).
• LED 9 is also used for daughter card status. Flash every 5 seconds = Okay.
IP Office Installation
IP Office
On all IP500 base cards, LED 1 is used to indicate general status. Okay status is
indicated by a flash every 5 seconds.
When a trunk daughter card is fitted, LED is used to indicate the general status of
that card. Okay status is indicated by a flash every 5 seconds.
15-601042 Issue 20b (16 July 2009)
Page 92