Avaya IP Office Installation Manual page 131

Procedure: Adding a WAN3 Module
1. Switch off power to the IP Office control unit.
2. Connect the WAN3 module to the control unit using the LAN cable.
3. Switch on power to the WAN3 10/100 module.
4. Switch on power to the IP Office Control Unit.
5. Using Manager receive the configuration from the IP Office system.
6. Select Control Unit. If the WAN3 10/100 module is not listed, right-click and select New. A Select WAN unit
window appears which will allows the network to be scanned for the WAN3 unit.
7. When the unit is located, select it and then OK.
8. Send the configuration back to the IP Office system.
IP Office Installation
IP Office 15-601042 Issue 20b (16 July 2009)
Page 130