Avaya IP Office Installation Manual page 122

Procedure: Installing Modem Cards
IP Office Installation
IP Office
IP400 Basic Installation: Fitting Modem Cards
1. Check that correct card has been supplied.
2. Ensure that you are wearing a anti-static wrist strap
connected to a suitable ground point.
3. Remove the 7 screws fixing the IP Office control unit
cover and slide the cover off the unit.
4. Locate the position for the card and its jumper block.
5. Using the card as a template locate the two holes in the
control unit circuit board. Insert the stand off pillars
into these holes.
6. Using minimal force and checking that the pins are
correctly located, push the card onto the jumper block
and stand off pillars.
7. If other cards are being fitted, proceed to
Cards.
8. Slide the control unit cover back on and replace the
cover screws.
9. Reapply power to the control unit and check that it
restarts correctly.
10.Using the IP Office Monitor application, confirm that
the correct number of modem channels are now
reported. They are shown by the value MDM= when
Monitor first connects to the control unit.
Fitting Trunk
15-601042 Issue 20b (16 July 2009)
Page 121