Conconfig; Syntax; Parameters; Notes - HP Integrity BL860c User's & Service Manual

state is entered and is different from the current state of a processor, its status changes on the next
boot. The last remaining configured processor in a server cannot be deconfigured.
Example 8 cpuconfig Command
Shell> cpuconfig
PROCESSOR INFORMATION
# of
CPU Logical
Slot CPUs
--- -------
0 1
1 1
Example 9 cpuconfig 2 Command
Shell> cpuconfig 2 off
CPU will be deconfigured on next boot.
Shell> cpuconfig
PROCESSOR INFORMATION
# of
CPU Logical
Slot CPUs
--- -------
0 1
1 1

conconfig

Use this command to configure the primary console, and turn other consoles on for mirroring from
the firmware.

Syntax

conconfig [index][on|off|primary]

Parameters

Index
on
off
primary

Notes

1. Primary console setting will take effect after reboot
2. P in status column indicates console is primary
3. S in status column indicates console is secondary
4. NC in status column indicates console is not configured
5. If a disabled console is set to primary it will be enabled
Example 10 conconfig Command
To display current primary operating system console
Shell> conconfig
CONSOLE CONFIGURATION
Index Status Type
----- ------ ----
1 NC
2 S
3 P
L3
Cache
Speed Size
--------- ----
1 GHz 1.5 MB
1 GHz 1.5 MB
L3
Cache
Speed Size
--------- ----
1 GHz 3 MB
1 GHz 3 MB
Specifies index of console to set as primary
Enables the specified console as a secondary console
Puts console into "Not Configured" (NC) state
Sets the specified console as primary
Device Path
-----------
Serial Acpi(PNP0501,0)
Serial Acpi(HWP0002,0)/Pci(1|1)
VGA Acpi(HWP0002,0)/Pci(4|0)
L4 Family/
Cache Model
Size (hex.) Rev
----- ------ ----
None 1F/01
None 1F/01
L4 Family/
Cache Model
Size (hex.) Rev
----- ------ ----
None 1F/00 B2
None 1F/00 B2
Processor
State
----------
B1 Active
B1 Active
Processor
State
----------
Active
Sched Deconf
EFI/POSSE Commands 159