Removing A Battery From A Snaphat Battery Holder; Monitor Recycling Or Disposal; Snaphat Battery Holder - IBM TS3310 Maintenance Information

Removing a Battery from a SnapHat Battery Holder

|
|
|
|
|
|
|
|
|
Figure 5-1. SnapHat battery holder
|
|
|
|
|

Monitor recycling or disposal

Perchlorate Material - California
Special handling may apply. See http://www.dtsc.ca.gov/hazardouswaste/
perchlorate for more information.
The foregoing notice is provided in accordance with California Code of
Regulations Title 22, Division 4.5 Chapter 33. Best Management Practices for
Perchlorate Materials. This product, part or both may include a lithium manganese
dioxide battery which contains a perchlorate substance.
The battery for this product is located on the Library Control Card. The yellow
component that holds the battery on the Library Control Card is referred to as a
"SnapHat," because it snaps on the Library Control Card and is identified by its
yellow color.
To remove the SnapHat battery holder from the Library Control Card:
1. Take the SnapHat holder by the short edges and pull it or snap it off the card.
2. When the SnapHat battery holder is free, dispose of the battery that is in the
holder according to the proper battery disposal practices for your location.
Flat panel display
The fluorescent lamp or lamps in the liquid crystal display contain mercury.
Dispose of it as required by local ordinances and regulations.
Monitors and Workstations
New Jersey - For information about recycling covered electronic devices in the
State of New Jersey, go to the New Jersey Department of Environmental Protection
web site at http://www.state.nj.us/dep/dshw/recycle/Electronic_Waste/
index.html
Oregon - For information regarding recycling covered electronic devices in the
state of Oregon, go to the Oregon Department of Environmental Quality site at
http://www.deq.state.or.us/lq/electronics.htm
Chapter 5. Safety and Environmental Notices
5-9