4.23 Setting the OFFSET FORCE
This function specifies the cutting force to be applied during initial blade control for checking the cutter-
blade direction at the start of operation. This is used to control the rotation of the cutter-blade tip during ini-
tial blade control when thick media is cut, and is therefore not necessary to specify for media of regular
thickness. The initial setting is "4." Increasing this setting increases the cutting force.
M O V E T O R . M A R K
F E E D
A U T O P R E F E E D
T A N G E N T I A L
A U T O R E G . M A R K
C L E A R B U F F E R
A X I S A L I G N M E N T
D I S T A N C E A D J U S T
P A G E L E N G T H
P L O T A R E A
E X P A N D
R O T A T E
M I R R O R
C O P Y
S O R T
R S - 2 3 2 C
C O M M A N D
B L A D E W E A R S E T U P
P E N U P / D O W N
T E S T M O D E
P E N U P S P E E D
O F F S E T F O R C E
O F F S E T A N G L E
S T E P P A S S
I N I T . D O W N F O R C E
L E N G T H U N I T
1
Step
Press the
(PAUSE) key to switch to PAUSE mode.
2
Step
Press the
(NEXT) or
O F F S E T F O R C E
3
Step
Press the
(ENTER) key to display the offset-force setting menu.
O F F S E T F O R C E 4
Use the
or
key to select the value to be set, and then press the
(ENTER) key to confirm.
CE5000-60:
"1" to "31"
CE5000-120:
"1" to "38"
To cancel the selection, press the
4
Step
Press the
(PAUSE) key to cancel PAUSE mode.
CHECKPOINT
This setting is retained in the internal memory even when
the power is turned off.
(Initial Cutting Force)
(PREV.) key until the following menu is displayed.
(NEXT) or
4 – 49
(PREV.) key.