Installing the DIMM air baffle
To install the DIMM air baffle, complete the following steps:
1. Align the air baffle as shown in the illustration.
2. Press the air baffle into position until it clicks into place.
3. Install the cover (see "Installing the cover" on page 130).
4. Slide the server into the rack.
5. Reconnect the power cord and any cables that you removed.
6. Turn on the peripheral devices and the server.
Removing the riser-card assembly
To remove the riser-card assembly, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and peripheral devices, and disconnect the power cord and
3. Remove the server from the rack and place it on a flat, static-protective surface.
4. Remove the cover (see "Removing the cover" on page 130).
Attention:
For proper cooling and airflow, replace the air baffle before you
turn on the server. Operating the server with an air baffle removed might
damage server components.
Attention:
For proper cooling and airflow, replace the air baffle before turning
on the server. Operating the server with an air baffle removed might damage
server components.
on page 127.
all external cables.
Air baffle
Chapter 5. Removing and replacing server components
133