Installing The System-Board Tray In A 2U Chassis - IBM x iDataPlex dx340 Series Problem Determination And Service Manual

Installing the system-board tray in a 2U chassis

To install the system-board tray in a 2U chassis, complete the following steps.
1. Slide the system-board tray into the chassis until it stops and the release
2. Reconnect the cables to the front of the system-board tray or expansion
3. Turn on the system-board tray (see "Turning on the system-board tray" on page
4. Make sure that the power-on LED on the system-board tray operator panel is lit
If you are installing a different system-board tray from the one that you removed,
you might have to configure the system-board tray, using the BIOS configuration
utility program. See "Using the BIOS configuration utility program" on page 156 for
more information.
76
System x iDataPlex dx340 Types 6385, 6386, 6389, 7831, 7832, and 7834: Problem Determination and Service Guide
latches click into place.
enclosure.
5).
continuously, indicating that the system-board tray is receiving power and is
turned on.