Table of Contents
Advertisement
CP3002-RC/CP3002-RA
3.4
Initial Installation Procedures for the CP3002-RA
The following procedures are applicable only for the initial installation of the CP3002-RA in a
system. Procedures for standard removal operations are found in their respective chapters.
To perform an initial installation of the CP3002-RA in a system proceed as follows:
1. Ensure that the safety requirements indicated in Chapter 3.1 are observed.
Warning!
The CP3002-RA provides no ESD discharge strips. Always ensure that
the CP3002-RA is discharged prior to installation in a CompactPCI back-
plane. Failure to comply with this instruction may cause damage to the
board or result in improper system operation.
Warning!
On the CP3002-RA, the chassis ground and the digital ground are not iso-
lated due to the direct mounting of the front panel to the heat sink. Thus,
the CP3002-RA can be operated only in a system with common grounding.
Failure to comply with this instruction may cause damage to the board or
result in improper system operation.
Warning!
Failure to comply with the instruction below may cause damage to the
board or result in improper system operation.
2. Ensure that the board is properly configured for operation in accordance with application
requirements before installing. For information regarding the configuration of the
CP3002-RA refer to Chapter 4. For the installation of CP3002-RA-specific peripheral de-
vices and Rear I/O devices refer to the appropriate sections in Chapter 3.
Warning!
Care must be taken when applying the procedures below to ensure that
neither the CP3002-RA nor other system boards are physically damaged
by the application of these procedures.
3. To install the CP3002-RA perform the following:
1. Ensure that no power is applied to the system before proceeding.
Warning!
When performing the next step, DO NOT push the board into the back-
plane connectors. Use the ejector handle to seat the board into the back-
plane connectors.
2. Carefully insert the board into the slot designated by the application requirements for
the board until it makes contact with the backplane connectors.
ID 1039-3625, Rev. 1.0
Installation
Page 3 - 7
Advertisement
Table of Contents
