Table of Contents
Advertisement
CP3002-RC/CP3002-RA
Table 1-1:
CP3002-RC/CP3002-RA Main Specifications (Continued)
FEATURES
Graphics controller
CompactPCI
Rear I/O
Gigabit Ethernet
USB
Serial
Serial ATA
Onboard Connectors
Debug LEDs
ID 1039-3625, Rev. 1.0
High-performance 3D graphics controller integrated in the processor:
Supports resolutions up to 2048 x 1536 pixels @ 60 Hz
•
Dynamic Video Memory Technology (DVMT)
•
Compliant with CompactPCI Specification PICMG 2.0 R 3.0:
System controller operation
•
32-bit, 33 / 66 MHz PCI master interface with dedicated PCIe-to-PCI
•
bridge
3.3 V or 5 V signaling levels (universal signaling support)
•
Support for up to four peripheral slots (4x REQ/GNT signals)
•
Note ...
To operate the CP3002-RC/CP3002-RA, 3U CompactPCI back-
plane with maximum five slots and rear I/O support on the system
slot is required.
The following interfaces are routed to the rear I/O CompactPCI connector J2:
1 x COMA (RS-232 signaling)
•
1 x COMB (RS-422 / RS-232 signaling)
•
2 x USB 2.0
•
1 x VGA analog port
•
4 x 10 Base-T/100 Base-TX/1000 Base-T Gigabit Ethernet interfaces
•
2 x SATA
•
5 x GPIs and 3x GPOs (LVTTL signaling)
•
Back-up voltage (3.3 V)
•
Up to four 10 Base-T/100 Base-TX/1000 Base-T Gigabit Ethernet interfaces
based on the Intel® 82580EB Quad Gigabit Ethernet controller:
Four ports on the rear I/O
•
Automatic mode recognition (Auto-Negotiation)
•
Automatic cabling configuration recognition (Auto-MDI/X)
•
Two USB 2.0 ports on the rear I/O interface
Two 16C550-compatible UARTs (RS-232/RS-422 signaling):
One RS-232 port on the rear I/O, COMA
•
One RS-422 / RS-232 port on the rear I/O, COMB
•
Serial ATA Host Controllers integrated in the Intel® QM57 chipset:
Provide support for three SATA ports, one onboard and two on rear I/O
•
Data transfer rates up to 300 MB/s
•
High-performance RAID 0/1/5 functionality on all SATA ports
•
One 34-pin extension connector, J3, for SATA Flash module (SSD)
•
JTAG connector, J4
•
XDP-SFF (debug) connector, J6
•
CompactPCI Connectors J1 and J2
•
Debug LEDs:
DLED0-3 (red / green): Onboard LEDs for debugging purposes
•
The DLEDs are located on the rear side of the board.
On the CP3002-RA, the DLEDs are visible on the front panel.
SPECIFICATIONS
Introduction
Page 1 - 9
Advertisement
Table of Contents
