Kontron CP3002-RC User Manual page 53

CP3002-RC/CP3002-RA
5. Using both hands, steadily apply enough force on the top and bottom of the front sur-
face of the board to engage it with the backplane.
Note ...
The chassis of ruggedized systems do not necessarily provide an objec-
tive means of determining when the board is properly seated in the back-
plane. During insertion it is possible however, to sense when the board
"gives way" and seats into the connector. At this point, the application of
more force does not result in further movement of the board.
In the event more boards are installed in a chassis, it is possible to com-
pare the board's front plane with the other boards. If they are all even with
one another, then they are all properly seated.
If in doubt that the board is properly seated, remove it and repeat steps 3
and 4 above.
6. Complete securing of the board by expanding the top and bottom wedge-locks. This
is done using a torque screwdriver with a 2.5 mm hex socket head. The recommended
torque value is 0.8 N-m (115 oz-in).
The CP3002-RC is now ready for initial operation. For operation of the CP3002-RC,
refer to the appropriate CP3002-RC-specific software, application, and system docu-
mentation.
ID 1039-3625, Rev. 1.0
Installation
Page 3 - 5