Standards For The Cp3002-Ra - Kontron CP3002-RC User Manual

CP3002-RC/CP3002-RA
1.7

Standards for the CP3002-RA

The CP3002-RA complies with the requirements of the following standards:
Table 1-3:

Standards for the CP3002-RA

TYPE
CE Emission
Immission
Electrical Safety
Mechanical Mechanical Dimensions
Environmental Climatic Humidity
WEEE
RoHS
Vibration
(Sinusoidal)
Single Shock
Permanent Shock
Note ...
Kontron performs comprehensive environmental testing of its products in accor-
dance with applicable standards.
Customers desiring to perform further environmental testing of Kontron prod-
ucts must contact Kontron for assistance prior to performing any such testing.
This is necessary, as it is possible that environmental testing can be destructive
when not performed in accordance with the applicable specifications.
In particular, for example, boards without conformal coating must not be
exposed to a change of temperature exceeding 1K/minute, averaged over a
period of not more than five minutes. Otherwise, condensation may cause irre-
versible damage, especially when the board is powered up again.
Kontron does not accept any responsibility for damage to products resulting
from destructive environmental testing.
ID 1039-3625, Rev. 1.0
ASPECT STANDARD
EN55022
EN61000-6-3
EN55024
EN61000-6-2
EN60950-1
IEEE 1101.10
IEC60068-2-78
Directive 2002/96/EC
Directive 2002/95/EC
IEC60068-2-6
IEC60068-2-27
IEC60068-2-29
Introduction
REMARKS
--
--
--
--
See note below
Waste electrical and electronic equipment
Restriction of the use of certain hazardous
substances in electrical and electronic
equipment
TBD
TBD
TBD
Page 1 - 13