Power Supply Specifications; For Gots Powered From The 100 To 240Vac Power Supply - Mitsubishi GT16 User Manual

3.3 Power Supply Specifications

The following describes the power supply specifications for the GT16.

3.3.1 For GOTs powered from the 100 to 240VAC power supply

3.3.2 For GOTs powered from the 24VDC power supply
HINT HINT HINT
Operation at momentary failure
• If an instantaneous power failure occurs in the power supply and continues for more than the permissible
period, the GOT will be reset.
• Make sure to power on the unit more than 5 seconds after power-off.
3.3.1 For GOTs powered from the 100 to 240VAC power supply
Item
Input power supply voltage
Input frequency
Input max. apparent power
Power consumption
At backlight off
Inrush current
Allowable momentary power
failure time
Noise immunity
Dielectric withstand voltage
Insulation resistance
Applicable wire size
Applicable solderless
terminal
Applicable tightening torque
(Terminal block terminal
screw)
GT1695M-XTBA
100 to 240VAC (+10% -15%)
50/60Hz 5%
150VA (maximum load)
64W or less
38W or less
28A or less (4ms) (maximum load)
20ms or less (100VAC or more)
1,500Vp-p noise voltage, 1 þs noise width (when measuring with a noise simulator under 25 to 60Hz
noise frequency)
1500VAC for 1 minute across power terminals and earth
10M or more across power terminals and earth by a 500V DC insulation resistance tester
2
0.75 to 2 [mm ]
Solderless terminal for M3 screw RAV1.25-3, V2-S3.3, V2-N3A, FV2-N3A
0.5 to 0.8 [N•m]
Specifications
GT1685M-STBA
110VA (maximum load)
46W or less
32W or less
3.3 Power Supply Specifications
GT1675M-STBA
GT1675M-VTBA
GT1675-VNBA
GT1672-VNBA
GT1665M-STBA
GT1665M-VTBA
GT1662-VNBA
100VA (maximum load)
39W or less
30W or less
3 - 17
1
2
3
4
5
6
7
8