Mitsubishi GT16 User Manual page 162

4.
Remove seven fixing screws on the GOT rear face with a screwdriver.
5.
Remove the case after passing the battery holder through the mounting hole.
When removing, take care of not cutting the cable of the battery holder.
(Expanded figure of part A in step 4)
6.
Pull out the tray for storing the cable connector of backlight.
(Expanded figure of part A in step 4)
7.
Disconnect the cable connector of backlight from the GOT side connectors.
8.
Press the backlight fixing latch (black) with your fingers, and pull out the backlight to the left.
Pull out the backlight so that the backlight does not hit the packing.
9.
Install a new backlight in the reverse procedure of removal.
When inserting a new backlight into the backlight replacement hole of the GOT, make sure not to damage the
sheaths of the cables.
Insert the backlight until it is fixed by the latch (black).
Pull the cable tight toward the right side of the tray.
Insert the tray until it is fixed. (Refer to figure in step 6)
Assemble the case in the reverse procedure of disassembly.
(Tighten the fixing screws on the GOT rear face with a torque of 0.36 to 0.48 N•m).
When installing the case, make sure that the cables are not stuck between the case and the GOT.
9 - 16 9.6 Backlight Replacement
Top
Latch
Packing
B
A