Mitsubishi GT16 User Manual page 103

* 1 This value differs depending on the cable used.
Please contact your local Mitsubishi Electric System & Service Co., Ltd.
The value indicated in the table is a reference value.
* 2 This value is for use of the coaxial cable 3C-2V (JIS C 3501).
For specifications of the cable, refer to the following manual.
•GOT1000 Series Connection Manual (Microcomputer, MODBUS Products, Peripherals) for GT Works3
•GOT1000 Series Connection Manual for GT Designer2/GT Works2
* 3 This value differs depending on the cable used.
If the bending radius of the cable used is greater than the value specified above, apply the value of the cable used.
* 4 GT1675-V, GT1672-V, GT1662-V, GT1655-V cannot be used.
* 5 Dimension when no battery is used
If a battery is used, the dimension when a CF card is used is required.

For installing CF card extension unit
(1) Installing location
(a) Depth dimensions
When the control panel side installation unit is installed on the control panel, 180mm in depth (including the
bending radius of the cable) is required inside the control panel.
(b) Available area for installation
When the control panel side installation unit is installed on the control panel, a distance of 25mm is required
around the unit.
Keep a distance of 25mm or more between the control panel side installation unit and the GOT.
The control panel side installation unit can be installed in the area shown in the following figure.
For the installation, do not give stresses, including an incorrect bending radius of the cable, on the
connection cable.
Appendix1 External Dimensions
180 or more
(7.09)
25 or less
(0.98)
500 or less
(19.69)
GOT
Available area
for installation
Unit : mm (inch)
500 or less
(19.69)
Prohibited area
for installation
Unit : mm (inch)
6.3 Mounting Position
1
2
3
4
5
6
7
8
6 - 5