Mitsubishi GT16 User Manual page 158

6.
Remove the backlight cables from the cable holder A by pulling the backlight cables one by one in the
arrow I direction and then in the arrow II direction.
7.
Pull out the backlight so that the backlight does not hit the packing.
8.
Install a new backlight so that its top plate is inserted between the metal parts of the backlight replacement
hole. When inserting a new backlight into the backlight replacement hole of the GOT, make sure not to
damage the sheaths of the cables.
Insert the backlight all the way in.
9.
Connect the backlight cable connector to the GOT board connector.
Do not put the cables of the backlight back to the cable holder A.Assemble the case in the reverse
procedure of disassembly. (Tighten the fixing screws on the GOT rear face with a torque of 0.36 to 0.48
N•m).
When installing the case, make sure that the cables are not stuck between the case and the GOT.
9 - 12 9.6 Backlight Replacement
Cable holder A
Packing
Fluorescent tube
Insert the top plate of
the backlight here.
Backlight
top plate
Top
Cable holder A
(Not used)