Mitsubishi GT16 User Manual page 161

5.
Remove the cable connector of the backlight from the connector of the GOT board.
(Expanded figure of part A in step 4)
Remove the cables from the cable holder.
6.
Push the backlight fixing latch (black) to the front face to pull out the backlight.
Pull out the backlight so that the backlight does not hit the packing.
Latch
7.
Install a new backlight in the reverse procedure of removal.
When inserting a new backlight into the backlight replacement hole of the GOT, make sure not to damage the
sheaths of the cables.
Insert the backlight until it is fixed by the latch (black).
Assemble the case in the reverse procedure of disassembly.
(Tighten the fixing screws on the GOT rear face with a torque of 0.36 to 0.48 N•m).
When installing the case, make sure that the cables are not stuck between the case and the GOT.

For GT16-60SLTT, GT16-60VLTT
1.
Turn off the GOT.
2.
Disconnect the power supply cable and the communication cable.
Remove the GOT from the control panel.
3.
Remove the right extension unit cover of the GOT.
Remove an extension unit, including a bus connection unit, if it is mounted.
Cable holder
Bottom
Fluorescent tube Packing
9.6 Backlight Replacement
9
10
9 - 15