Mitsubishi GT16 User Manual page 156

6.
Push the backlight fixing latch (black) to the front face to pull out the backlight.
Pull out the backlight so that the backlight does not hit the packing.
(When replacing GT16-80SLTT)
(When replacing GT16-70SLTT/VLTT)
The latch is on the right side of the backlight.
(Edge-on view figure of the part A in step 4)
7.
Install a new backlight in the reverse procedure of removal.
When inserting a new backlight into the backlight replacement hole of the GOT, make sure not to damage the
sheaths of the cables.
Insert the backlight until it is fixed by the latch (black).
Assemble the case in the reverse procedure of disassembly.
(Tighten the fixing screws on the GOT rear face with a torque of 0.36 to 0.48 N•m).
When installing the case, make sure that the cables are not stuck between the case and the GOT.
9 - 10 9.6 Backlight Replacement
Latch
Latch
Packing
Fluorescent tube
Cable
Fluorescent tube
Push the latch to the front face side with the finger.
(If the latch cannot be reached, use a screw driver etc.)
Packing