Mitsubishi GT16 User Manual page 142


Stand
1.
Set the stand so that the front side of the GOT to be mounted faces the front.
2.
Adjust the mounting angle of GOT with the angle adjusting screw of the stand.
3.
Put the GOT into the Stand from the front side and fix it using the fixtures.
For the GOT mounting method, refer to the following.

Attachment
(1) GT15-70ATT-98, GT15-60ATT-97, GT15-60ATT-96, GT15-60ATT-87, GT15-60ATT-77
The following figures show an example of the GT15-60ATT-97 installation.
Follow the same procedure for installing the other models.
1.
The model is indicated on the attachment.
The upper part of the attachment has the model indication.
(Example of model indication)
2.
Hang the two upper hooks on the upper part over the mounting holes in
the control panel.
Refer to the figure shown in step1.
3.
While lifting the attachment upward, hang the two lower hooks on the
lower part of the control panel.
4.
Fix the attachment to the control panel with four clamp screws in the
torque range of 0.2 to 0.28N•m.
5.
Place the GOT into the attachment from the front, and fix it by tightening
the mounting screws included with the GOT in the torque range of 0.36
to 0.48N•m.
8 - 20 8.3 Option
6.5 Installation Procedure
Model
Upper
Upper part
part
Lower part Lower part