Mitsubishi GT16 User Manual page 160

8.
Install a new backlight so that its top plate is inserted between the metal parts of the backlight replacement
hole. When inserting a new backlight into the backlight replacement hole of the GOT, make sure not to
damage the sheaths of the cables.
Insert the backlight all the way in.
9.
Connect the backlight cable connector to the GOT board connector. Secure the backlight cables with the
cable holder B.Assemble the case in the reverse procedure of disassembly. (Tighten the fixing screws on
the GOT rear face with a torque of 0.36 to 0.48 N•m).
When installing the case, make sure that the cables are not stuck between the case and the GOT.

For GT16-70VLTN
1.
Turn off the GOT.
2.
Disconnect the power supply cable and the communication cable. Remove the GOT from the control panel.
3.
Remove the right extension unit cover of the GOT.
Remove an extension unit, including a bus connection unit, if it is mounted.
4.
Remove eight fixing screws on the GOT rear face with a screwdriver.
9 - 14 9.6 Backlight Replacement
Insert the top plate of
the backlight here.
Backlight
top plate
Top
Cable holder B
(Used)
Bottom
A
Top