Mitsubishi GT16 User Manual page 140

POINT POINT POINT
Before mounting the GOT onto the control panel.
Please confirm all surroundings. Whether the rubber packing part is surely covered to prevent going into such as
the liquids in the board.
4.
Mount the GOT onto the control panel.
When the control panel is dirty, clean the control panel.
The panel cutting dimensions and mounting screw tightening torque with the protective cover for oil are the
same as those without the cover.
For how to mount the GOT onto the control panel, refer to the following.
POINT POINT POINT
Precautions for protective cover for oil
• The protective cover for oil is a consumable product.
Check the cover for scratch, damage or dirt at regular intervals, and replace with new one if necessary.
• Do not push the protective cover for oil with pointed tools, including mechanical pencils and screwdrivers.
Doing so causes scratches and damages of the cover.
• Do not clean the protective cover for oil with bleaches, thinners, organic solvents, corrosive chemicals, and
others. Doing so causes changes in shape and color of the cover.
• When the protective cover for oil is attached to the GOT, do not stretch and bend the cover too much.
Doing so may cause a separation between the sheet and rubber.
• Do not place or use the protective cover for oil in direct sunshine.
• When the protective cover for oil gets dusts, wipe the dusts off with a damp cloth.
• When the protective cover for oil is used, the USB interface on the GOT front face cannot be used.
• When the protective cover for oil is used, the human sensor does not correctly operate.
Disable the human sensor with the utility.
For the human sensor setting, refer to GT16 User's Manual.
(Basic Utility) 2.2.3 Display setting operations
• Do not attach and remove the protective cover for oil frequently.
Doing so reduces oil resistance and chemical resistance.
• This cover does not guarantee protection in all environments.
This cover may not be appropriate for use in environments where it is exposed to oil and chemicals for a long
time or environments with large amounts of oil mist.
8 - 18 8.3 Option
Make sure that corners of protective
cover for oil match those of GOT front.
6. INSTALLATION
Protectivecover
for oil
Panel cut
dimensions
Mounting metal fixture
Control panel