Panel Cutting Dimensions - Mitsubishi GT16 User Manual

6.2 Panel Cutting Dimensions

(1) Panel cutting dimensions when installing GOT
Make an installation hole on the control panel with the dimensions shown below.
Make space of 10mm above and below the hole respectively for the installation fittings.
(2) Panel cutting dimensions when installing CF card extension unit
Make an installation hole on the control panel with the dimensions shown below.
Make space of 10mm on the left and right of the hole respectively for the installation fittings.
POINT POINT POINT
Precautions before executing the panel cut
• If the GOT is installed on the panel, remove the GOT from the panel temporarily.
6 - 2 6.2 Panel Cutting Dimensions
A
A
* Panel thickness: 2 to 4 mm or less
GOT A [mm] (inch)
383.5(15.10)
GT1695M-X
(+2(0.08), 0(0))
302(11.89)
GT1685M-S
(+2(0.08), 0(0))
GT1675M-S
GT1675M-V 289(11.38)
GT1675-VN (+2(0.08), 0(0))
GT1672-VN
GT1665M-S
227(8.94)
GT1665M-V
(+2(0.08), 0(0))
GT1662-VN
153(6.02)
GT1655-V
(+2(0.08), 0(0))
* Panel thickness: 2 to 4 mm or less
GOT A [mm] (inch)
GT15-CFEX- 94(3.70)
C08SET (+2(0.08), 0(0))
B [mm] (inch)
282.5(11.12)
(+2(0.08), 0(0))
228(8.98)
(+2(0.08), 0(0))
200(7.87)
(+2(0.08), 0(0))
176(6.93)
(+2(0.08), 0(0))
121(4.76)
(+2(0.08), 0(0))
B [mm] (inch)
33(1.30)
(+2(0.08), 0 (0))