For GT16-60VLTN
1.
Turn off the GOT.
2.
Disconnect the power supply cable and the communication cable.
Remove the GOT from the control panel.
3.
Remove the right extension unit cover of the GOT.
Remove an extension unit, including a bus connection unit, if it is mounted.
4.
Remove seven fixing screws on the GOT rear face with a screwdriver.
5.
Remove the case after passing the battery holder through the mounting hole.
When removing, take care of not cutting the cable of the battery holder.
(Expanded figure of part A in step 4)
6.
Pull out the tray for storing the cable connector of backlight.
(Expanded figure of part A in step 4)
Top
7.
Disconnect the cable connector of backlight from the GOT side connectors.
Bottom
B
A
9.6 Backlight Replacement
9
10
9 - 17