Mitsubishi GT16 User Manual page 188

Error
Error message
code
Warning! Built-in Flash ROM
505
needs replacement soon.
Warning! Backlight needs
506
replacement.
Warning! Display section needs
507
replacement.
Warning! Touch panel needs
508
replacement.
Warning! Built-in Flash ROM
509 needs replacement. Change the
GOT.
510 Clock data input out of range
511 A blown backlight is detected.
520 Insufficient Flash ROM capacity
Insufficient user memory (RAM)
521
capacity
Unnecessary file deleted to
522
create new file.
Device writing error. Correct
524
device.
Unable to read/write alarm log
525
files under different projects.
526 File conversion failed.
10 - 24 10.3 Error Message and System Alarm
The dedicated GS is notifying that the built-in flash memory writing times
have reached 80% or more of the set times.
The GOT must be replaced. In that case, Data backup and re-setting are
needed. The GOT can also be restored by turning off the notification
signal manually. In such a case, turn it OFF after setting a value greater
than the addition times.
The dedicated GS is notifying that the backlight power on addition time
has reached the set time or more.
The GOT can be restored by executing the addition times reset function
after replacing the backlight. The GOT can also be restored by turning off
the notification signal manually. In such a case, turn it OFF after setting a
value greater than the addition time.
The dedicated GS is notifying that the display section power on addition
time has reached the set time or more.
The GOT can be restored by executing the addition times reset function
after replacing the display section. The GOT can also be restored by
turning off the notification signal manually. In such a case, turn it OFF
after setting a value greater than the addition time.
The dedicated GS is notifying that the touching count of the touch key has
reached the set count number or more.
The GOT can be restored by executing the addition times reset function
after replacing the touch key. The GOT can also be restored by turning off
the notification signal manually. In such a case, turn it OFF after setting a
value greater than the addition times.
The dedicated GS is notifying that the built-in flash memory writing times
have reached the set times or more.
The GOT must be replaced. In that case, Data backup and re-setting are
needed. The GOT can also be restored by turning off the notification
signal manually. In such a case, turn it OFF after setting a value greater
than the addition times.
The value that is input as clock data is out of the input enabled range.
In this case, the input value is not accepted.
Confirm the input range of the value to be input as clock data, and input
the proper value again.
The backlight is shut off or the lighting status of the backlight is unstable.
If the error is detected repeatedly, contact your local Mitsubishi
representative.
The capacity for the buffering area is insufficient in the build in flash
memory
• Confirm whether there are no mistakes in specified buffering area size.
The capacity for the buffering area is insufficient in the user memory
(RAM)
• Confirm whether there are no mistakes in specified buffering area size.
The old file of different contents has been deleted and a new file has been
created.
Note that the old file is deleted and the new file is created if the file of the
same name with different contents exists when creating files.
When writing in the device, error occurred.
Correct the device.
Unable to read the alarm log file saved by the different project.
Confirm the alarm log file and where to store the alarm log file.
The file specified for the file conversion does not exist.
Check the settings for specifying a file to be converted.
Action
Channel No.
storage