Table of Contents
Advertisement
Chapter 2 - CLI Commands
2.4
Port-2 Interface Context
Context path: View > Enable > Config > Port-2 interface
This context provides commands for configuring Port-2.
duplex
Supported on: Wi² AP
duplex (auto | half | full)
Sets the duplex mode on Port-2.
Parameters
auto
half
full
end
Supported on: Wi² AP
end
Switches to parent context.
speed
Supported on: Wi² AP
speed (auto | 10 | 100)
Sets the speed of Port-2.
Parameters
auto
100
10
vlan
Supported on: Wi² AP
vlan <id>
Sets the default VLAN ID. Range: 1 - 4094. All outgoing traffic that does not
have a VLAN already assigned to it, is sent on this VLAN.
no vlan
Deletes the default VLAN ID.
52
Lets the Wi² AP automatically set duplex mode based
on the type of equipment it is connected to.
Forces the port to operate in half duplex mode.
Forces the port to operate in full duplex mode.
Lets the Wi² AP automatically set port speed based on
the type of equipment it is connected to.
Forces the port to operate at 100 mbps.
Forces the port to operate at 10 mbps.
Wi² AP CLI Reference Guide
Advertisement
Table of Contents
