Air Interface Parameters (Au And Su) - Alvarion BreezeAccess II System Manual

2-38
! DHCP Client
" DHCP Options – Displays the current status of the DHCP
(Dynamic Host Configuration Protocol) support, and allows
selecting a new operation mode. The available options are:
#
#
#
" Access to DHCP – To define the port through which the unit is
allowed to communicate with a DHCP server. The options are:
#
#
#
NOTE:
The Access to DHCP option is not available in the GU, as this module does
not have a wireless link interface.
! Show IP Parameters – Displays the current values of the IP
Parameters.
Air Interface Parameters (AU and
SU)
Hopping Frequencies Setting Parameters
Depending on the applicable Country Standard, there are two methods
for setting the hopping frequencies to be used:
a. If the Country Standard is other than ISM FCC, the hopping
frequencies should be selected using the Hopping Set and Hopping
Sequence (Shift) parameters. The same values for these parameters
must be configured in the AU and in all the SUs that it serves.
b. If the Country Standard is either ISM FCC, the hopping frequencies
can be selected using the same method based on the Hopping Set
and Hopping Sequence (Shift) parameters. However, in these cases
it is also possible to set the frequencies using Hybrid Digital
Manual Revision: 1.0
BreezeACCESS Version 4.5 Operations and Administration
Disable – Use manual procedure for configuring the IP
parameters.
DHCP Only – Search for a DHCP Server and obtain the IP
parameters from it (IP Address, Subnet Mask and Default
Gateway Address).
Automatic – Search for a DHCP Server for configuration of
the IP parameters. If a DHCP Server is not found within
approximately 40 seconds, use the currently configured IP
parameters.
The default is Disable.
From Wlan Only
From Ethernet Only
From Both Ethernet & WLAN
The default for an Access Unit is From Ethernet Only. The
default for a Subscriber Unit is From Wlan Only.