Chapter 2 - CLI Commands
firmware-update uri
Supported on: Wi² AP
firmware-update uri <uri>
Sets the URI where the Wi² AP will retrieve new firmware.
no firmware-update uri
Clears the firmware URI.
firmware-update weekday
Supported on: Wi² AP
firmware-update weekday (everyday | monday | tuesday | wednesday |
thursday | friday | saturday | sunday)
Sets the day when the scheduled firmware upgrade will take place.
snmp-server trap firmware-update
Supported on: Wi² AP
snmp-server trap firmware-update
Send a trap on firmware update.
no snmp-server trap firmware-update
Do not send a trap on firmware update.
access-controller restrict location
Supported on: Wi² AP
access-controller restrict location (gateway | mac <mac address>)
Identifies the access controller the Wi² AP will communicate with.
Parameters
gateway
mac
<mac address>
service-sensor
Supported on: Wi² AP
service-sensor
Enables the service sensor. The service sensor polls a target device at
present intervals. If the device does not respond, the radio is shut off.
no service-sensor
Disables the service sensor.
42
Use the default gateway as the service controller.
Use the specified MAC address as the gateway.
MAC address. Specify 6 pairs of hexadecimal numbers
separated by colons, with the values a to f in lowercase.
For example: 00:03:52:0a:0f:01
Wi² AP CLI Reference Guide