Table of Contents
Advertisement
Chapter 2 - CLI Commands
bridge protocol ieee
Supported on: Wi² AP
bridge protocol ieee
Enable the bridge spanning tree protocol to prevent undesirable loops from
occurring in the network that may result in decreased throughput.
no bridge protocol ieee
Disable the bridge spanning tree protocol.
bridge protocol ieee vlan
Supported on: Wi² AP
bridge protocol ieee vlan
Enable the bridge spanning tree protocol for VLANs.
no bridge protocol ieee vlan
Disable the bridge spanning tree protocol for VLANs.
ip route gateway
Supported on: Wi² AP
ip route gateway<destination>/<mask> <gateway> <[metric]>
Adds a static route.
no ip route gateway <destination>/<mask> <gateway> <[metric]>
Removes the specified static route.
Parameters
<destination>
<mask>
<gateway>
<metrix>
dot1x reauth
Supported on: Wi² AP
dot1x reauth
Enable this option to force 802.1X client stations to reauthenticate.
no dot1x reauth
Disables 802.1X reauthentication.
48
Traffic addressed to this IP address will be routed.
Indicates the number of bits in the destination address
that is checked for a match.
Indicates the IP address of the gateway the Wi² AP will
forward routed traffic to. The gateway address must be
on the same subnet as one of the available interfaces
(Internet port or LAN port).
Indicates the priority of a route. If two routes exist for
a destination address then the Wi² AP chooses the one
with the lower metric.
Wi² AP CLI Reference Guide
Advertisement
Table of Contents
