Table of Contents
Advertisement
Config Context
ip name-server switch-over
Supported on: Wi² AP
ip name-server switch-over
Switch over to primary when active.
no ip name-server switch-over
Do not switch over to primary when active.
snmp-server trap unauthorized-ap
Supported on: Wi² AP
snmp-server trap unauthorized-ap
Send a trap when a rogue access point is detected.
no snmp-server trap unauthorized-ap
Do not send this trap.
snmp-server trap unauthorized-ap interval
Supported on: Wi² AP
snmp-server trap unauthorized-ap interval <number>
If set to 0, then traps are only sent when a rogue access point is detected. If
set to 0, the entire list of rogue access points is sent each time the interval
expires.
wireless-scan
Supported on: Wi² AP
wireless-scan
Enables wireless neighborhood scanning.
no wireless-scan
Disables wireless neighborhood scanning.
wireless-scan period
Supported on: Wi² AP
wireless-scan period <seconds>
Specifies the interval between wireless neighborhood scans.
Parameters
Scanning interval. Range: 10 - 600 seconds.
<seconds>
wireless-scan url
Supported on: Wi² AP
wireless-scan url <location>
Sets the URL of the file that contains a list of all authorized access points.
Wi² AP CLI Reference Guide
45
Advertisement
Table of Contents
