Table of Contents
Advertisement
Chapter 2 - CLI Commands
Changes to this parameter should only be made according to the
recommendations of your ISP. Incorrectly setting this parameter can reduce
the throughput of your Internet connection.
Parameters
<bytes>
pppoe unnumbered
Supported on: Wi² AP
pppoe unnumbered
Enable unnumbered mode.
no pppoe unnumbered
Disable unnumbered mode.
This feature is useful when the Wi² AP is connected to the Internet and NAT
is not being used. Instead of assigning two IP addresses to the Wi² AP, one to
the Internet port and one to the LAN port, both ports can share a single IP
address. This is especially useful when a limited number of IP addresses are
available to you.
58
Maximum size (in bytes) of a PPPoE packet when
transmitting. Range: 500 - 1500 bytes.
Wi² AP CLI Reference Guide
Advertisement
Table of Contents
