Table of Contents
Advertisement
Chapter 2 - CLI Commands
• All other traffic is blocked. This includes NetBIOS traffic regardless of its
source/destination address. TTPS traffic not addressed to the CNx (or
upstream device) is also blocked, which means wireless client stations
cannot access the management tool on other Alvarion products.
Default filters for outgoing wireless traffic
Applies to traffic sent from the CNx to wireless client stations.
Accepted
• Any IP traffic coming from the upstream device, except NetBIOS packets.
• PPPoE traffic from the upstream device.
• IP broadcast packets, except NetBIOS
• ARP and DHCP Offer and ACK packets.
• Any traffic coming from the CNx itself, including 802.1x.
Blocked
• All other traffic is blocked. This includes NetBIOS traffic regardless of its
source/destination address.
mac-filters local
Supported on: Wi² AP
mac-filters local
Enables the MAC filter list.
no mac-filters local
Disables the MAC filter list.
mac-filters
Supported on: Wi² AP
mac-filters <address>
Adds an address to the MAC filter list.
no mac-filters <address>
Remove the specified address from the MAC filter list.
Parameters
<address>
Description
This feature enables you to control access to the Wi² AP based on the MAC
address of client stations. You can either block access or allow access,
depending on your requirements. When both this option and the MAC-based
authentication options are enabled, the following applies: if a customer’s
MAC address does not appear in the MAC filtering list, then MAC-based
authentication takes place for that customer.
70
MAC address. Specify 6 pairs of hexadecimal numbers
separated by colons, with the values a to f in lowercase.
For example: 00:03:52:0a:0f:01
Wi² AP CLI Reference Guide
Advertisement
Table of Contents
