Snmp-Server Location; Snmp-Server Port; Snmp-Server Readonly; Snmp-Server Readwrite - Alvarion Wi² AP CLI Reference Manual

Chapter 2 - CLI Commands

snmp-server location

Supported on: Wi² AP
snmp-server location <name>
Specifies the location where the Wi² AP is installed.
no snmp-server location
Deletes location information.
Parameters
<name>

snmp-server port

Supported on: Wi² AP
snmp-server port <port number>
Sets the port the Wi² AP will use to respond to SNMP requests.
Parameters
<port number>

snmp-server readonly

Supported on: Wi² AP
snmp-server readonly <community>
Sets the read-only community string.
no snmp-server readonly
Deletes the read-only community string.

snmp-server readwrite

Supported on: Wi² AP
snmp-server readwrite <community>
Sets the read-write community string.
no snmp-server readwrite
Deletes the read-write community string.

snmp-server trap

Supported on: Wi² AP
snmp-server trap
Enables support for SNMP traps.
no snmp-server trap
Disables support for SNMP traps.
32
Location where the Wi² AP is installed.
SNMP port number. Range 1 - 65535.
Wi² AP CLI Reference Guide