Dot11 Automatic Frequency Period; Dot11 Automatic Frequency Time; Dot11 Automatic Transmit-Power; Dot11 Automatic Transmit-Power Period - Alvarion Wi² AP CLI Reference Manual

Chapter 2 - CLI Commands
no dot11 automatic frequency
Disable automatic frequency selection.

dot11 automatic frequency period

Supported on: Wi² AP
dot11 automatic frequency period (disabled | 1h | 2h | 4h | 8h | 12h
| 24h)
Specify how often the frequency setting is re-evaluted when automatic
frequency selection is enabled.

dot11 automatic frequency time

Supported on: Wi² AP
dot11 automatic frequency time <time>
Specify when the channel should be re-evaluated.

dot11 automatic transmit-power

Supported on: Wi² AP
dot11 automatic transmit-power
Enables automatic transmit power selection.
no dot11 automatic transmit-power
Disables automatic transmit power selection.

dot11 automatic transmit-power period

Supported on: Wi² AP
dot11 automatic transmit-power period (1h | 2h | 4h | 8h | 12h |
24h)
Sets the interval at which the transmit power setting is re-evaluated when
automatic power selection is enabled.

multicast rate

Supported on: Wi² AP
multicast rate (1 | 2 | 5.5 | 6 | 9 | 11 | 12 | 18 | 24 | 36 | 48 |
54)
Sets the transmit rate for multicast traffic.
This is a fixed rate, which means that if a station is too far away to receive
traffic at this rate, then the multicast will not be seen by the station. By
rasing the multicast rate you can increase overall throughput significantly.
62 Wi² AP CLI Reference Guide