Table of Contents
Advertisement
</mask>
ip address dhcp client-id
Supported on: Wi² AP
ip address dhcp client-id <id>
Specifies an ID to identify the Wi² AP to a DHCP server. This parameter is
not required by all ISPs.
no ip address dhcp client-id
Deletes the specified DHCP client id.
end
Supported on: Wi² AP
end
Switches to parent context.
pppoe auto-reconnect
Supported on: Wi² AP
pppoe auto-reconnect
The Wi² AP will automatically attempt to reconnect if the connection is lost.
no pppoe auto-reconnect
The Wi² AP will not automatically attempt to reconnect if the connection is
lost.
pppoe mru
Supported on: Wi² AP
pppoe mru <bytes>
Specifies the maximum receive unit.
Changes to this parameter should only be made according to the
recommendations of your ISP. Incorrectly setting this parameter can reduce
the throughput of your Internet connection.
Parameters
<bytes>
pppoe mtu
Supported on: Wi² AP
pppoe mtu <bytes>
Specifies the maximum transmit unit.
Wi² AP CLI Reference Guide
Subnet mask in CIDR format. Specifies the number of
bits in the mask.
Maximum size (in bytes) of a PPPoE packet when
receiving. Range: 500 - 1500 bytes.
WAN IP Interface Context
57
Advertisement
Table of Contents
