Table of Contents
Advertisement
Config Context
snmp-server trap network-trace
Supported on: Wi² AP
snmp-server trap network-trace
Send a trap when a network trace is started or stopped.
no snmp-server trap network-trace
Do not send this trap.
firmware-update automatic
Supported on: Wi² AP
firmware-update automatic
Enables scheduled firmware upgrades.
no firmware-update automatic
Disables scheduled firmware upgrade.
The Wi² AP can automatically retrieve and install firmware from a local or
remote URL at preset times. By placing Wi² AP firmware on a web or ftp
server, you can automate the update process for multiple units.
When the update process is triggered the Wi² AP retrieves the first 2K of the
firmware file to determine if it is different from the active version. If
different, the entire firmware file is then downloaded and installed.
(Different means older or newer. This enables you to return to a previous
firmware version if required).
Configuration settings are preserved during the update unless stated
otherwise in the release notes for the firmware. However, all active
connections will be terminated. Customers will have to log in again after the
Wi² AP restarts
firmware-update start
Supported on: Wi² AP
firmware-update start
Upload the firmware based on a specified URI. This URI can be set with the
command: firmware-update uri.
firmware-update time
Supported on: Wi² AP
firmware-update time <time>
Sets the time of day the scheduled firmware upgrade will take place.
Parameters
Time as hh:mm:ss. For example: 15:44:00.
<time>
Wi² AP CLI Reference Guide
41
Advertisement
Table of Contents
