Delete Ip Filter All; Ip Filters; Active; Beacon Dtim Count - Alvarion Wi² AP CLI Reference Manual

</mask>

delete ip filter all

Supported on: Wi² AP
delete ip filter all
Deletes all addresses from the IP filter list.

ip filters

Supported on: Wi² AP
ip filters
Activates the IP filter which enables you to block wireless-to-wired LAN
traffic on this profile based on its destination address.
no ip filters
Disables the IP filter for this profile.

active

Supported on: Wi² AP
active
Enable this VAP (virtual network).
no active
Disable this VAP (virtual network).

beacon dtim count

Supported on: Wi² AP
beacon dtim count <number>
Defines the DTIM period in the beacon.
Client stations use the DTIM to wake up from low-power mode to receive
multicast traffic. The Wi² AP transmits a beacon every 100 ms. The DTIM
counts down with each beacon that is sent, therefore if the DTIM is set to 5,
then client stations in low-power mode will wake up every 500 ms (.5
second) to receive multicast traffic.

public forwarding

Supported on: Wi² AP
public forwarding (any | 802.1x | none)
Enables support for traffic exchange between wireless client stations.
Wi² AP CLI Reference Guide
Subnet mask in CIDR format. Specifies the number of
bits in the mask.
Virtual AP Context
73