Table of Contents
Advertisement
Chapter 2 - CLI Commands
2.6
WAN IP Interface Context
Context path: View > Enable > Config > WAN IP interface
This context provides commands for configuring various IP-networking related
settings.
pppoe client user
Supported on: Wi² AP
pppoe client user <username> <password>
Sets the PPPoE username and password.
no pppoe client user
Deletes the PPPoE username.
Parameters
<username>
<password>
ip address mode
Supported on: Wi² AP
ip address mode (dhcp | pppoe | static)
Sets the IP addressing mode for Port-2.
Parameters
dhcp
pppoe
static
ip address
Supported on: Wi² AP
ip address <ip address>/<mask>
Sets a static IP address for the port.
Parameters
<address>
56
The username assigned to you by your ISP. The Wi² AP
will use this username to log on to your ISP when
establishing a PPPoE connection.
The password assigned to you by your ISP. The Wi² AP
will use this username to log on to your ISP when
establishing a PPPoE connection.
Dynamic host configuration protocol. The DHCP server
will automatically assign an address to the Wi² AP,
which functions as a DHCP client.
Point-to-point protocol over Ethernet. The PPPoE
server will automatically assign an IP address to the
Wi² AP. You need to supply a username and password so
the Wi² AP can log on.
This option enables you to manually assign an IP
address to the Wi² AP.
IP address.
Wi² AP CLI Reference Guide
Advertisement
Table of Contents
