Chapter 2 - CLI Commands
Parameters
<address>
</mask>
soap-server http authentication
Supported on: Wi² AP
soap-server http authentication
Enable the SOAP server HTTP authentication.
no soap-server http authentication
Disable the SOAP server HTTP authentication.
soap-server http authentication password
Supported on: Wi² AP
soap-server http authentication password
Set the SOAP server HTTP authentication password.
soap-server http authentication username
Supported on: Wi² AP
soap-server http authentication username
Set the SOAP server HTTP authentication username.
soap-server port
Supported on: Wi² AP
soap-server port <port number>
Sets the port the Wi² AP will use to respond to SOAP requests.
Parameters
<port number>
soap-server ssl
Supported on: Wi² AP
soap-server ssl
SSL enabled for SOAP server.
no soap-server ssl
SSL disabled for SOAP server.
soap-server ssl with client certificate
Supported on: Wi² AP
soap-server ssl with client certificate
Enable the use of client certificate with SSL for SOAP server.
36
IP address.
Subnet mask in CIDR format. Specifies the number of
bits in the mask.
SOAP port number. Range 1 - 65535.
Wi² AP CLI Reference Guide