Attaching The Interposer Tray - Gestetner B070 Service Manual

Attaching the Interposer Tray

[C]
1. If you are installing cover interposer tray on the B468/B469 finisher, insert the
spacer [A] and snap it into position.
NOTE: If you are installing the cover interposer tray on the B478, do not install
this spacer. This spacer is for the B468/B469 installation only.
2. Pick up the cover interposer tray, align the keyholes [B] with the shoulder
screws [C], then slide the cover interposer down onto the screws.
3. Secure the cover interposer with the screw [D] ( x 1, M3 x 6).
NOTE: 1) If you are installing the cover interposer tray on the B468, skip the next
section and go directly to "Docking the Finisher with the Machine" on
page 1-74.
2) If you are installing the cover interposer tray on the B478, go to the next
section, install the corner plates on the B478, then go to "Docking the
Finisher with the Machine" on page 1-74.
SM
CÓPIA NÃO CONTROLADA
[B]
Booklet Finisher
B468/B469 Only
1-71
CÓPIA NÃO CONTROLADA
COVER INTERPOSER TRAY (B470)
[A]
B470I004.WMF
[D]
B070/B071