Dip Sw 100 (Main Board) - Gestetner B070 Service Manual

2.12 DIP SW 100 (MAIN BOARD)

The settings of DIP SW 100 on the main finisher board should remain set to OFF
(zero in the table below). These settings should not be changed by the customer or
the customer engineer during normal operation or testing. These settings are
provided for reference only.
DIP SW 101
1 2 3 4
0 0 0 0
1 0 0 0
0 1 0 0
1 1 0 0
0 0 1 0
1 0 1 0
1 1 1 0
*1
: The following procedure repositions the trays to the shipping position.
1) Make sure that the main switch is turned off.
2) Turn on DIP SW101-3.
3) Turn on the main switch. The finisher automatically repositions the trays to the shipping
position.
4) After the finisher completes moving the trays, turn off DIP SW101-3.
SM
CÓPIA NÃO CONTROLADA
Mode
Default
Not Used
Cover Feeder Test
Cover Feeder Test
Move to Shipping Position
Cover Feeder Check
Cover Feed Test
13
CÓPIA NÃO CONTROLADA
DIP SW 100 (MAIN BOARD)
Content
Operation Check
Operation Check
*1
See note below.
Operation Check
Operation Check
B468