Gestetner B070 Service Manual page 119

[E]
6. Remove the tape from the back of the Velcro patch, attach the patch to the right
corner [A] of the controller box, then attach the antenna [B] to the patch.
7. Remove the tape from the back of the Velcro patch, attach the patch to the left
corner [C] of the controller box, then attach the antenna [D] to the patch.
8. Pass the connectors through the cover [E].
9. Connect each antenna to a terminal [F] and attach the cover.
NOTE: 1) Attach the antennas as described above. However, if you change
the location of either antenna, please remember that the antennas
should be separated by at least 40~60 mm (1.5~2.5").
2) Set up the antennas in an area that is free of interference from
electrical equipment that generates a strong electromagnetic field.
3) Always detach the antennas from the corners of the machine and
disconnect them before moving the machine.
4) If reception is poor, move the machine and antennas closer to the
access point.
10. Switch the machine on and print a configuration page to confirm that the
machine recognizes the installed board for IEEE 802.11b (Wireless LAN):
User Tools> Printer Features> List Test Print> Configuration Page
SM
CÓPIA NÃO CONTROLADA
INSTALLATION OF MFP CONTROLLER OPTIONS
[F]
1-85
CÓPIA NÃO CONTROLADA
[A]
[B]
[D]
[C]
B580I109.WMF
B070/B071