Firmware Update; Before You Begin - Gestetner B070 Service Manual

FIRMWARE UPDATE

5.10 FIRMWARE UPDATE
To update the firmware for this machine, you must have the new version of the
firmware downloaded onto an SD (Secure Digital) Card. The SD Card is inserted
into the C3 slot on the right side of the controller box, viewed from the back of the
machine.

5.10.1 BEFORE YOU BEGIN...

An SD card is a precision device, so always observe the following precautions
when handling SD cards:
• Always switch the machine off before inserting an SD card. Never insert the SD
card into the slot with the power on.
• After the power has been switched on, never remove the SD card from the
service slot.
• Never switch the machine off while the firmware is downloading from the SD
card.
• Store SD cards in a safe location where they are not exposed high temperature,
high humidity, or exposure to direct sunlight.
• Always handle SD cards with care to avoid bending or scratching them. Never
drop an SD card or expose it to other shock or vibration.
Keep the following points in mind while you are using the firmware update
software:
• "Upload" means to send data from the machine to the SD card, and "download"
means to send data from the SD card to the machine.
• To select an item on the LCD, touch the appropriate button on the soft touch-
screen of the LCD, or press the appropriate number key on the 10-key pad of the
operation panel. For example, "Exit (0)" displayed on the screen means you can
touch the Exit button on the screen, or press the
panel of the copier.
• Before starting the firmware update procedure, always make sure that the
machine is disconnected from the network to prevent a print job for arriving while
the firmware update is in progress.
⇒
Important Notice when updating several firmwares simultaneously
To ensure that error codes do not occur when installing several types of firmware
simultaneously, follow the procedure outlined below:
1. Before installing any firmware, install the "System" firmware individually.
2. After successfully installing the "System" firmware, turn the machine main
power OFF/ON and confirm that the machine boots up to Ready status
normally.
3. The remaining firmware may now be installed simultaneously.
B070/B071
CÓPIA NÃO CONTROLADA
5-102
CÓPIA NÃO CONTROLADA
Rev. 05/2004
button on the operation
SM