Attaching The Corner Plates For The B - Gestetner B070 Service Manual

COVER INTERPOSER TRAY (B470)

Attaching the Corner Plates for the B478

CAUTION: The corner plates are installed on the B478 only. Attach the cover
interposer tray to the finisher before attaching the corner plates.
Right Rear Corner Plate (B478 only)
[E]
[A]
1. Temporarily attach the screws [A] (with about two turns) to the right end of the
finisher extension table [B] ( x 2, tapping M4 x 8)
NOTE: The holes are not visible because they are covered with tape. Just
punch the screws through the holes.
2. Align the cutouts [C] of the right rear corner plate [D] with the screws and attach
the plate.
NOTE: If there is a gap [E] between the plate and the tray extension attached
to the side of the finisher, loosen the two screws below the table
extension (not shown), align the table extension with the corner of the
finisher and plate, then re-tighten the tray extension screws.
3. With a long screw driver inserted through the cutouts in the right rear corner
plate [D], tighten the screws to fasten the right rear corner plate to the table
extension [B].
B070/B071
CÓPIA NÃO CONTROLADA
[B]
1-72
CÓPIA NÃO CONTROLADA
[C]
[D]
B470I009.WMF
SM