Installation - Gestetner B070 Service Manual

BYPASS TRAY (B512)

1.5.2 INSTALLATION


CAUTION
Switch the machine off and unplug the machine before starting the
following procedure.
[A]
1. If the LCT is connected to the machine, disconnect it.
CAUTION: To avoid damaging the LCT connectors and ground wire, separate
the LCT and copier about 20 cm (8"), and disconnect the
connectors ( x 4) and ground wire ( x 1) before pulling the
LCT away from the machine.
2. Remove the tab fence from the left top cover [A].
3. Remove all tapes and shipping material from the bypass tray [B].
4. Remove the paper slot cover [C] ( x 2) and discard the screws.
5. Use the edge of a fine tip flathead screwdriver to remove the smaller three
covers [D].
B070/B071
CÓPIA NÃO CONTROLADA
[B]
B512I002.WMF
1-42
CÓPIA NÃO CONTROLADA
[C]
[D]
B512I003.WMF
SM