Multi-Function Output Operation Selection; Multi-Function Output On/Off Delay Time - Omron RX Series User Manual

5 Basic Settings

5-10-2 Multi-function Output Operation Selection

• Set the multi-function output P1 to P5 terminals and the multi-function relay output (MA, MB) terminal
to either NO (Normally open contact) or NC (Normally closed contact) individually.
Parameter
No.
Multi-function Output P1
C031
Operation Selection
Multi-function Output P2
C032
Operation Selection
Multi-function Output P3
C033
Operation Selection
Multi-function Output P4
C034
Operation Selection
Multi-function Output P5
C035
Operation Selection
Multi-function Relay Output
C036 (MA, MB) Operation
Selection

5-10-3 Multi-function Output ON/OFF Delay Time

• Each multi-function output terminal can be allocated with the ON/OFF delay time.
• All output signals turn ON/OFF immediately when the set conditions are satisfied. Depending on the
selected signal, chattering may occur. In such a case, use this function to hold or delay the signal.
• Set the parameter for each output terminal. For the output terminal, multi-function output terminals
P1 to P5 and a multi-function relay output (MA, MB) terminal are provided. For the output terminals
and the corresponding parameters, refer to the table below.
Parameter
No.
C130 Multi-function Output P1 ON Delay Time
C132 Multi-function Output P2 ON Delay Time
C134 Multi-function Output P3 ON Delay Time
C136 Multi-function Output P4 ON Delay Time
C138 Multi-function Output P5 ON Delay Time
C140 Multi-function Relay Output ON Delay Time
C131 Multi-function Output P1 OFF Delay Time
C133 Multi-function Output P2 OFF Delay Time
C135 Multi-function Output P3 OFF Delay Time
C137 Multi-function Output P4 OFF Delay Time
C139 Multi-function Output P5 OFF Delay Time
C141 Multi-function Relay Output OFF Delay Time
5 - 60
Function name
00: NO (Normally open contact)
01: NC (Normally closed contact)
00: NO contact between MA and
01: NC contact between MA and
Function name
High-function General-purpose Inverter 3G3RX-V1 User's Manual (I578-E1)
Data
MC, NC contact between MB
and MC
MC, NO contact between MB
and MC
Data
0.0 to 100.0
0.0 to 100.0
Default data Unit
00 –
01 –
Default data Unit
0.0 s
0.0 s