Step 1540-17; Step 1540-18; Step 1540-19 - IBM S85 pSeries 680 Service Manual

Step 1540-17

1. If it is not already off, turn off the power.
2. Remove all adapters from slots 5, 6, and 7 that are not attached to the boot device.
3. Label and record the location of any cables attached to the adapters.
4. Record the slot number of the adapters.
5. Turn on the power.
6. When the TTY screen displays Enter 0 to select this console, press the 0 key
on the TTY terminal's keyboard.
Was the boot successful?
No
Yes

Step 1540-18

1. If it is not already off, turn off the power.
2. Remove all adapters from slots 9 and 10 that are not attached to the boot device.
3. Label and record the location of any cables attached to the adapters.
4. Record the slot number of the adapters.
5. Turn on the power.
6. When the TTY screen displays Enter 0 to select this console, press the 0 key
on the TTY terminal's keyboard.
Was the boot successful?
No
Yes

Step 1540-19

1. If it is not already off, turn off the power.
2. Remove all adapters from slots 11, 12, 13, and 14 that are not attached to the boot
device.
3. Label and record the location of any cables attached to the adapters.
4. Record the slot number of the adapters.
5. Turn on the power.
6. When the TTY screen displays Enter 0 to select this console, press the 0 key
on the TTY terminal's keyboard.
Was the boot successful?
No
Yes
Go to "Step 1540-14" on page 124.
Go to "Step 1540-20" on page 126.
Go to "Step 1540-15" on page 124.
Go to "Step 1540-20" on page 126.
Go to "Step 1540-22" on page 126.
Go to "Step 1540-20" on page 126.
Chapter 3. Maintenance Analysis Procedures
125