Adapter Parameters - IBM S85 pSeries 680 Service Manual

Adapter Parameters

Select the Adapter Parameters option from the Network Parameters menu to view an
adapter's hardware address, as well as configure network adapters that require setup. A
screen similar to the following displays when you make this selection:
Adapter Parameters
Device
1. Gigabit Ethernet
2. ethernet
3. token-ring
4. fddi
(PRESS ENTER AFTER MAKING A SELECTION) ===>
Select an adapter on this screen to display configuration menus for that adapter. If
ethernet is selected, you can set parameters that control how the ethernet adapter
communicates with the network. For example, the following screen shows the menu for
the Ethernet adapter configuration:
1. Data Rate [Auto]
2. Full Duplex [No]
Selecting the Data Rate option allows you the change the media employed by the
Ethernet adapter:
.----------------.
| DATA RATE
| 1. 10 Mbps
| 2. 100 Mbps
| 3. Auto
'----------------'
===>
Slot Hardware Address
5: U0.1-P1-I5/E1 0004ac7c8628
3: U0.1-P1-I3/E1 0060949d21db
11: U0.1-P1-I11/T1 0004ac62a672
10: U0.1-P1-I10/Q1 00005a40aeff
.------.
|X=Exit|
'------'
|
|
|
|
Chapter 8. System Management Services
483