Table of Contents
Advertisement
#
# PROGRAMMING NOTE: No blanks between double quote marks (").
condout:
connect:
retry:
disconnect:
condin:
waitcall:
640
Service Guide
send "AT&F*E0E0\r"
ignore "0\r" or "OK\r\n" timeout 2 # Ignore modem response.
send "AT#F0*Q2S8=6\r"
expect "0\r" or "OK\r\n" timeout 2 # Confirm commands successful
send "ATV0X0S0=0\r"
expect "0\r" or "OK\r\n" timeout 2 # Confirm commands successful.
done
send "ATDT%N\r"
expect "1\r" busy "7\r" timeout 60 # Expect a connection response.
done
send "A/"
expect "1\r" busy "7\r" timeout 60 # Expect a connection response.
done
delay 2
send "+++"
delay 2
send "ATH0\r"
ignore "0\r" or "OK\r" timeout 2
send "ATE0Q1\r"
ignore "0\r" timeout 1
done
send "AT&F*E0E0\r"
ignore "0\r" or "OK\r\n" timeout 2 # Ignore modem response.
send "AT#F0*Q2\r"
expect "0\r" or "OK\r\n" timeout 2 # Confirm commands successful
send "ATV0X0S0=2\r"
expect "0\r" timeout 2
done
ignore "2\r" timeout 1
expect "2\r" timeout 10
# Reset to factory defaults.
# *E0=data compression disabled
# E0=echo disabled
# Trellis modulation disabled
# Retrain with adaptive rate
# Set ,=6second
# Numeric response code
# AT compatible messages
# Auto-Answer disabled
# Tone dialing command.
# %N from Call Home setup.
# Repeat the previous command.
# Separate from previous data.
# Assure command mode.
# Allow mode switching delay.
# Set modem switch-hook down
# (i.e., hang up).
# Ignore modem response.
# Initialize modem: Echo OFF,
# Disable responses.
# Reset to factory defaults.
# *E0=data compression disabled
# E0=echo disabled
# Trellis modulation disabled
# Retrain with adaptive rate
# Numeric response code
# AT compatible messages
# Answer on 2nd ring
# Confirm commands successful.
# Ignore first ring.
# Pick up second ring
# or timeout.
# Expect a connection response.
Advertisement
Table of Contents
