Table of Contents
Advertisement
Yes
11. The problem is no longer present. You may have an intermittent problem.
This ends the procedure.
12. Perform the following:
a. Power off the system.
b. Install one of the regulator assemblies that were removed in step 1 on
c. Remove all bus load (processor and memory cards) except the clock card and
d. Power on the system.
Does a power supply reference code occur?
No
Yes
13. Have you installed all the regulator assemblies that were removed in step 1
on page 114?
No
Yes
116
Service Guide
Go to step 11.
page 114.
SPCN card.
Go to step 13.
The regulator assembly you just installed is failing, replace the regulator
assembly.
This ends the procedure. Go to "Map 0410: Repair Checkout" in the
Diagnostic Information for Multiple Bus Systems.
Go to step 12.
This ends the procedure.
Advertisement
Table of Contents
