IBM S85 pSeries 680 Service Manual page 184

Table 5. Firmware Error Codes. (continued)
Error Code Description
20EE0005 Invalid IP parameter (>255)
20EE0006 No recognized SCSI adapter present
20EE0007 Keyboard not found
20EE0008 No configurable adapters found in the
20EE0009 Unable to communicate with the service
20EE000B The system was not able to find an
162
Service Guide
system
processor
operating system on the device list that
was attempted.
Action/ Possible Failing FRU
Enter valid IP parameter.
Example: 255.192.002.000
This warning occurs when the selected
SMS function cannot locate any SCSI
adapter supported by the function. If a
supported SCSI adapter is installed:
1. Replace SCSI adapter(s).
2. Replace the I/O drawer planar in
drawer(s) containing SCSI
adapter(s).
1. Plug in keyboard.
2. Replace service processor card;
Location: U0.1-P1-X1.
This warning occurs when the selected
SMS function cannot locate any
devices/adapters supported by the
function. If a supported device is
installed:
1. Replace the device or adapter. (See
notes on page 157.)
2. Replace the I/O drawer planar in the
drawer(s) containing the
device/adapter.
1. Replace the service processor card.
Location: U0.1-P1-X1.
2. Replace the I/O planar in primary
drawer
Location: U0.1-P1.
Modify the boot sequence (also known
as boot list) to include devices that are
known to contain a copy of the
operating system. This can be
accomplished by using the system
management services menus. For
example, select a hard disk known to
have a copy of the operating system as
the first and only device in the boot
sequence (boot list) and attempt to boot
again.